What are the installation tasks for aluminum profile extrusion machines
The installation of these six types of equipment on the aluminum profile extrusion machine production line is very important. Generally, professional installation personnel are dispatched by the aluminum profile extrusion machine equipment manufacturer to work. So, how to install and what special attention should be paid to? The installation of aluminum profile extrusion equipment is related to whether it can be put into production in a timely manner in the later stage. Therefore, this article is still very practical, and the small edge may help you sort it out. If there are any shortcomings, please add them under the evaluation!
What are the installation tasks for aluminum profile extrusion machines
1. Lift in place
(1) Before installing the aluminum profile extrusion machine, it is necessary to inspect and clean the foundation screws, and rust the bolts. Generally, a layer of rust inhibitor is applied, and then the foundation screws are placed in the holes.
(2) The location where the cushion blocks are placed should be cleaned and tidy. Each set of cushion blocks cannot exceed 4 in quantity. And the flat cushion block and inclined cushion iron should be used in conjunction with the application.
(3) The maximum weight of a single piece of aluminum profile extrusion machine is required, and attention should be paid to preventing damage to the extrusion machine.
(4) When lifting the aluminum profile extruder, it is necessary to ensure the stability of the body.
2. Self alignment and leveling
(1) Screw jacks should be used for adjustment, and the cushion blocks should be compatible with the application.
(2) When aligning, a level gauge is generally used, with an accuracy of 0.02mm/m.
(3) After the leveling is completed, the foundation screws can be tightened.
3. Installation of the main plunger and reverse rack
(1) Bolts should be used for connection, and in alignment, the axis of the extrusion cylinder should be used as the standard, and then a micrometer and an internal micrometer should be used for alignment.
(2) The coaxiality between the extrusion cylinder and the piston cannot exceed 0.05mm/m. Moreover, the flatness between the end face of the extrusion cylinder and the end face of the piston should not exceed 0.05mm/m.
Only when the installation work is done well can the adjustment be successful, which is related to the production of aluminum profiles. Therefore, it must not be careless. If the aluminum profile extrusion equipment is used, professional technical personnel will go to the installation and debugging, which can be reassuring. After the installation and debugging is completed, the staff of the aluminum profile factory will also be taught some operation methods of the aluminum profile extrusion machine production equipment. If there is anything unclear in the later stage, You can always contact their after-sales personnel!