What should be considered in the installation of aluminum profile extrusion machine
At present, the cooling and spraying system of the new aluminum profile extruder is set behind the extrusion mouth of the aluminum profile extruder, arranged along the discharge direction of the aluminum profile, and has a bearing device that carries the aluminum profile. The bearing device spray cooling device is set above the bearing device, and the blast cooling device is set at the bearing device, which has an upper opening and a channel through which the aluminum profile passes. By adopting this structure, the extruded aluminum profile can be cooled quickly, This greatly improves the overall production efficiency and production efficiency.
What should be considered in the installation of aluminum profile extrusion machine
Now we know that the gearbox of the extruder includes the gear box, the output shaft is set in the gear box, the thrust bag is set on the left wall of the gear box, the gear box is connected to the extruder sleeve by the thrust package, and the power output end of the output shaft is connected to the extruder screw through the thrust component. The traditional output shaft is divided into two parts, the output shaft and the coupling sleeve, Its output shaft can be pre-assembled into standard parts and other parts of the gear box, and its connecting sleeve can be quickly customized according to user requirements to shorten production.
At present, a new type of extruder is used, including its base fixed on the four corners of the base, its mold clamping box and power device, which are fixed on the base for rotation, one side of the mold clamping box is fixed, the fixed mold is installed, and the movable mold is set on the other side of the fixed mold. The device has a frosting layer on the surface of the lower cone table and the inner wall of the cone through hole, so that the raw material is finely polished, To ensure the uniformity of material particles, heating can be more complete and faster, and indirectly improve the work efficiency.
The slide plate is driven down or up by the connecting rod of the extruder, so that the gap between the lower conical table and the conical through-hole can be adjusted, so as to control the fall of the material. After the acceleration, wait for the cooling to be unified, so as to save resources, filter through the activated carbon particles, discharge through the exhaust pipe, and transport to the next process for treatment, so as to ensure the air quality of the injection molding workshop.