How to control the high temperature of Cu-Al profile extruder
At present, the research of copper and aluminum profile extrusion machine has been gradually improved, and the materials or design performance has been tested, and the new type of copper and aluminum profile extrusion machine, which is a high-speed operating equipment, has made little progress in all aspects for designers, familiar with the simulation test and working conditions, and the actual conclusion confirms that the AC synchronous servo system of designers is only limited to the copper and aluminum profile extrusion machine, Therefore, the energy copper aluminum extrusion machine is very accurate.
How to control the high temperature of Cu-Al profile extruder
The new generation of copper and aluminum profile extrusion machine, including digital control panel with touch screen and displacement sensor, through signal detection and measurement, and manual speed control extrusion, the application of this system makes the whole machine work more stable and reliable, and effectively improves the extrusion quality of aluminum profile. The key factor is that the design speed of copper and aluminum profile extrusion machine is aluminum processing, which has indirect impact on the productivity and extrusion quality according to pressure, For railway vehicle aluminum as alkali, with effectively increasing extrusion, aluminum can reduce the processing speed of concave and convex outlet temperature according to pressure.
According to the numerical simulation and theoretical analysis, the results of the Cu-Al profile extrusion machine confirmed the appropriate range of aluminum alloy stamping rate. Now the extrusion process of Cu-Al profile extrusion machine at high temperature is used for operation. The high temperature alloy with high deformation resistance and ductility should have a speed compatible with strict temperature to ensure product quality. Each Cu-Al profile extrusion machine includes a speed range, and the extrusion will not cause cracks, Therefore, the speed of metal return to the hole of the mold is called the entrance.
Especially when the extrusion tube is on the contrary, the deviation after extrusion is thicker than the wall thickness, which is due to the fact that during the reverse extrusion process, to ensure that the puncture needle is well eroded out of the whole compression cycle, if the small diameter tube is loose, it can be expanded and re-extruded in the copper and aluminum extrusion machine, which effectively reduces waste and loss and improves the performance of extrusion.